Bicycle Tracker Mount: AirTag / Installed
View
AirTag
FineTrack

AirTag & FineTrack · Bottle-cage mounting

Bicycle Tracker Mount

In stock

Give your tracker a discreet home beneath your bottle cage. A two-piece enclosure attaches at the frame’s existing bottle-mount points.

Original holder design by m1chale

View listing on Etsy
Ask about this design

Choose the holder made for your tracker. Fits 65 mm mounting spacing; two M5 screws included. Check frame and bottle-cage clearance before ordering. Tracker, bottle cage and bicycle are not included. The off-white enclosure is the product; bicycle context is illustrative.

Manufactured from premium PETG-HF for thermal resistance and structural durability.

Why it’s designed this way

A two-piece enclosure gives the tracker a discreet position beneath the bottle cage. These holders are manufactured by Bankasi; the original holder design is credited to m1chale in the preview.

Before you order

  • Choose AirTag or UGREEN FineTrack to match the tracker you own.
  • Mounting-hole spacing: 65 mm, measured centre to centre. Two M5 screws included.
  • Check bottle-cage, frame and screw engagement clearance. Tracker, cage and bicycle not included.

Setup & use

  1. The bottle cage coming off the bicycle frame.
    Step 1

    Take off the bottle cage

    Remove the bottle cage and its screws from the frame’s bottle-cage bosses.

  2. The tracker between the two halves of the holder.
    Step 2

    Put the tracker in

    Place your AirTag or UGREEN FineTrack in the holder and lay the other half over it. The screws will clamp the halves together.

  3. The holder and the bottle cage lining up with the frame bosses.
    Step 3

    Stack holder and cage

    Line up the holder’s slots with the bosses and place the bottle cage back over it.

  4. Two M5 screws going through the cage and holder into the frame bosses.
    Step 4

    Fit the two M5 screws

    Fit the two included M5 screws through the cage and holder into the bosses and tighten them. Their clamping force holds the two halves shut.

  5. The finished mount under the bottle cage, highlighted.
    Step 5

    Check before riding

    Follow your bicycle maker’s tightening guidance, then check the cage, bottle and screws are secure before riding.

Drawn from the product’s 3D models. Cases, desks, devices and other surroundings are illustrative; drawings are not measured plans.

Care & troubleshooting

Wipe with a soft, slightly damp cloth, then dry. Avoid solvents and hot-water cleaning. Inspect attachment regularly and after impacts. The holder does not guarantee theft prevention.

Open this guide in Help

From the Workbench

All stories